EV Charger Installation

Can My Panel Handle a Level 2 EV Charger?

Before you buy a Level 2 charger, find out whether your electrical panel can actually support it. Here's how electricians check, and what your options are if it's tight.

Licensed · Bonded · Insured·CA Lic. C-1098584

November 12, 2026
Can My Panel Handle a Level 2 EV Charger?

Many 200-amp panels can handle a Level 2 EV charger without an upgrade, while 100-amp panels are often tight once you count AC, cooking and other large loads. The only reliable way to know is a load calculation by a licensed electrician. A typical Level 2 charger runs on a dedicated 240-volt circuit, often 40 amps for a 32-amp charger or 60 amps for a 48-amp charger, because EV charging is a continuous load sized at 125%. If your panel is short on capacity, the options are a smaller charger setting, a load management device, or a panel upgrade.

Last updated: November 2026

How does an electrician check your panel's capacity?

  1. Read the main breaker rating (100, 125, 200 amps and so on) and check for open breaker spaces.
  2. Run a load calculation using the electrical code's method, which counts your heating and cooling, cooking, dryer, water heater and other loads.
  3. Review actual usage where utility data is available, since that can show real peak demand.
  4. Size the charger circuit to fit what's left.

Why does Southern California heat matter for EV charging?

Your biggest household load is often air conditioning. In the Antelope Valley and Santa Clarita, summer highs often reach the high 90s°F and sometimes past 100°F. If your car charges in the evening while the AC is still running hard, both loads stack up. That's why a load calculation matters more here than in milder climates, and why many homeowners schedule charging overnight when demand drops.

What if your panel doesn't have enough capacity?

  • Turn the charger down: most Level 2 chargers can be set to a lower amperage, which still charges overnight for most daily driving.
  • Add load management: devices that monitor your home's load and throttle the charger so you never exceed your service rating.
  • Upgrade the panel or service: the best long-term choice if you're also planning a heat pump, ADU or second EV. See our electrical panel upgrade service.

Do you need a permit for a Level 2 charger?

Yes. A new 240-volt circuit requires a permit and inspection in every jurisdiction we serve. Your electrician should pull it and coordinate with your utility (SCE, LADWP, BWP or GWP) if a service change is needed. Utilities and the U.S. Department of Energy also publish EV charging guidance, and some utilities offer rebates, so ask before you buy.

For the bigger picture, read our EV charger installation guide for homeowners and businesses, or see our EV charger installation service. B&M Electrical Services has 30+ years of experience as a licensed California contractor (C-1098584).

Frequently Asked Questions

Can I plug my EV into a regular outlet instead?

Yes. Level 1 charging on a standard 120-volt outlet works, but it's slow, adding a few miles of range per hour. It's fine for low daily mileage.

Is a 100-amp panel ever enough for a Level 2 charger?

Sometimes, especially with gas appliances or with load management. A load calculation tells you for sure.

Can you install a charger for two EVs?

Yes. Options include two circuits, or a power-sharing setup between two chargers, depending on your panel capacity.

Find out if your panel is EV-ready. Call Us Today for a Free Estimate at (661) 904-9377 or schedule your service online.

Where We Work

Areas We Serve

Dispatched from Acton, CA — serving homes and businesses across the Antelope Valley, Santa Clarita and greater Los Angeles County.

Your Home Deserves Safe, Dependable & Modern Electrical Systems

Call Us Now(661) 676-0615