Recessed Lighting Installation in Acton, CA

Most Acton recessed-lighting installs run $125–$225 per can installed, including the fixture, romex, switch leg, dimmer and patching. A typical kitchen with 6 cans and a Lutron dimmer runs $850–$1,400. A whole-home layout with 20+ cans, multiple dimmer zones and smart controls runs $3,500–$7,000.

Yes. About 90% of our recessed-lighting work is retrofits in existing ceilings. We use slim-profile LED cans that need only 2.5″–4″ of ceiling depth, fish romex through finished walls and attics, and patch any small drywall cuts. No major demo required.

A general rule is one 4″–6″ LED can per 16–25 sq ft of floor space for general illumination. A 12'x14' kitchen typically wants 4–6 general cans on a 30–36″ grid, plus over-counter task lighting (under-cabinet LED tape or pendant lights). We design the actual layout based on your cabinets, island and prep zones.

2700K for living rooms and bedrooms (warm, relaxing), 3000K for kitchens and bathrooms (clean, slightly warm), 3500K–4000K for offices, garages and workshops (neutral, alert). Always confirm CRI 90+ for natural color rendering. We use Halo HLB and Lithonia Wafer cans with selectable color temperature.

If insulation will or might contact the fixture (almost always the case in Acton attics), yes — IC-rated cans are required by NEC 410.116. All slim-profile retrofit LED cans we install are IC-rated and airtight by default, which also helps with attic air-sealing.

Yes. LED retrofit kits drop into existing 4″–6″ can housings and screw into the existing socket — no rewiring needed. We replace 1990s–2000s incandescent or CFL cans with modern dimmable LED retrofits that use 80% less energy and last 25,000+ hours. A 6-can living room takes 30–45 minutes.